Sony DCR-VX9000 - Manual (Page 89)

89
Additional information
About the ID of the Remote Commander
You can avoid having the digital camcorder accidentally respond to signals from other
remote commanders by setting the VTR4/ID/VTR2 switch to ID. Use the supplied
Remote Commander when you set the switch to ID. When you use the Remote
Commander for the first time, register the ID following the procedure below. Once you
have registered the ID, you do not need to do so again.
(1) Open the cover, then press MENU to display the menu in the viewfinder.
(2) Press
or to select COMMANDER, then press EXECUTE.
(3) Press or to select ID SET.
(4) Set VTR4/ID/VTR2 on the Remote Commander to ID.
(5) Point the Remote Commander at the Remote Commander sensor on the digital
camcorder and press p STOP on the Remote Commander.
After the beep sound, the ID of the Remote Commander is registered, and the
COMMANDER is set to ID in the menu system.
(6) Press MENU to erase the menu display.
MENU
D ZOOM OFF
16 : 9 WIDE
ZEBRA
COMMANDER
BEEP
FRAME REC
INT REC
[ MENU ] : END
MENU
COMMANDER VTR4
OFF
ID
ID SET
[ MENU ] : END
MENU
COMMANDER VTR4
OFF
ID
ID SET
COMMANDER [ STOP ] : ID SET
MENU
ID
VTR 4
STOP
4
1
5
2
3
VTR 2