Sony MZ-R501 - Manual (Page 27)

27
4
Repeat step 3 and enter all characters
of the label name.
5
Press MENU/ENTER for 2 seconds
or more
.
The track or disc is labeled.
Labeling a track during
playback
1
Insert a disc and play the track you
want to label.
2
Press MENU/ENTER, press
SELECT
>/. repeatedly until
“EDIT” flashes in the display, and
then press MENU/ENTER again.
“
” and “Name” flash in the
display.
3
Press MENU/ENTER.
The track is ready to be labeled.
4
Follow steps 3 to 5 of “Labeling a
disc during stop”.
Labeling a track or a disc
during recording
1
While recording, press MENU/
ENTER, press SELECT
>/.
repeatedly until “EDIT” flashes in the
display, and then press MENU/
ENTER again.
“
” and “Name” flash in the
display.
2
To label a track, press MENU/
ENTER while “
” and “Name” are
flashing.
To label a disc, press SELECT
>/
. repeatedly until “ ” and
“Name” flash in the display.
The track or disc is ready to be
labeled.
3
Follow steps 3 to 5 of “Labeling a
disc during stop”.
To cancel labeling
Press x.
Notes
• When the recording is stopped while labeling
a track or a disc during recording, or when the
recording moves on to the next track while
labeling a track, the input at that point is
entered automatically.
• “LP:” has automatically been added at the
beginning of track names for tracks recorded
in LP2 stereo or LP4 stereo.
Relabeling recordings
Follow the steps corresponding to the
labeling method until the disc or track is
ready to be labeled. Enter a new character
over the one you want to change, then
press MENU/ENTER.
Notes
• You cannot relabel premastered MDs or label
MDs that have not been recorded.
• The recorder is able to display, but cannot
label using Japanese “Katakana” characters.
• The recorder cannot rewrite a disc or track
name of more than 200 letters that was created
by another device.
END SEARCH/
VOL – Delete a letter and
move back all
following letters to
the left pressing both
buttons together.
x Cancel labeling.
Press To