Smeg ALFA41XE2 - Manual (Page 4)

21
Instructions for the installer
2. OVEN INSTALLATION
2.1 Positioning
The oven must be installed on a free-standing horizontal work top. The
distance from the rear wall must allow easy access to the terminal board
for connection of the power supply cable. Installation must be carried out
by a
qualified technician and in compliance with EEC DIRECTIVES
currently in force.
For correct operation, you must
not place products on top of each
other.
If several products are installed
side by side, maintain a minimum
distance of 10 mm between each
of them as shown in the figure.
2.2 Electrical connection
Make sure the voltage and the cross-section of the power cord match the
specifications indicated on the identification plate positioned on the side
of the oven. Do not remove this plate for any reason.
The oven is fitted with an H07RN-F three-core cable for operation at 220-
240V
∼ and a power supply plug.
The supplied cable is a H07RN-F 3 x 1.5 mm
2
three-core cable.
The power supply cable must be replaced by the manufacturer or by an
authorised service centre to prevent any risks.
The terminal marked with this symbol connects parts together that are
normally at zero potential. Connect the appliances appropriately using
this terminal in order to make sure that they are equipotential.
The plug and wall-mounted socket must be of the same type (in
accordance with CEI regulations). Make sure that the supply line is
suitably earthed. Avoid use of adapters and shunts.