Smeg ALFA41XE2 - Manual (Page 9)

26
Instructions for the User
4.5 Manual cooking
The manual program is “P40” and can be edited by the user, but does not
save the cooking parameters set in memory. To select this program
proceed as follows:
• Save the program temporarily, as described in chapter 4.3 Editing /
saving a program. Unlike saved programs, the cooking time can be
set to infinite; the display will show the text “InF”.
• After saving it, do NOT return to the “OFF” condition. Press the
“START” button. The appliance will perform a pre-heating cycle,
showing the text “PrEh” on the display.
• When preheating is finished, a series of beeps lasting 3 seconds
indicate that is possible to proceed with the cooking operation. The
text “PrEh” will flash on the display.
• To start the cooking, keep the “START” button pressed for 2 seconds.
The display will show, in order, the temperature set, the time
remaining until the end of cooking and the program selected.
• It is possible to start cooking early before the preheating temperature
is reached, by keeping the “START” button pressed for 3 seconds.
• During cooking, it is possible to modify the temperature by turning the
knob to the or symbols; it will continue with the new setting
after 3 seconds.
• During the last minute of cooking, only the countdown of the
remaining 60 seconds will be displayed. At the end, a beep and the
text “End” flashing (for 20 minutes) will indicate that cooking has been
completed.
• At the end of the cooking operation, to perform the same program
again press the “START” button once more.
• To return to the “OFF” status keep the “STOP” button pressed for 4
seconds. The parameters set for the program are deleted.