Siemens 4015 - Manual (Page 101)

100
Appendix
Gigaset 4015 Comfort, IM, A31008-G4015-J102-1-7619 ANHA.FM 16.5.02
Appendix
Maintenance
Simply wipe the base station and handset with a damp cloth or an
antistatic wipe. Never use a dry cloth as this can cause static dis-
charge.
Contact with liquid
If the handset should come into contact with liquid,
on no account switch the device on.
Remove all batteries immediately.
Allow the liquid to drip out of the device, and then dab all parts of the
device dry.
Keep the handset with the batteries removed in a warm, dray place for
at least 72 hours. In many cases, you will then be able to use it again.
Questions and answers
If any questions occur to you while you are using your device, we are
available 24 hours a day at www.my-siemens.com/customercare.
You will find the most frequently asked questions and answers below.
Question Possible cause Possible solution
No display Handset not activated Hold down end call key a
for 1 second
Batteries empty Charge or replace the
batteries (page 9)
No reaction to key-
stroke Keypad protection acti-
vated Hold down the
ª
key for 1 second
No radio connection to
the base station – E.g.
base station 1 is flash-
ing Handset outside the
base station range Move closer to the base
station
Handset not registered Register the handset
(page 73)
Base station not activat-
ed Check the connector at
base station (page 8)
Handset that is in the
base station is not
charging Line seized by a second
handset for a long peri-
od Maximum charging
power is only possible
while nobody is mak-
ing calls
Handset does not ring Ringer off Activate the ringer
Hold down the
«
key
!