Sony CSS-HD2 - Manual (Page 14)

1-GB
The Remote Commander range is less than
five meters (for indoor use). Point the Remote
Commander at the remote sensor of the Cyber-
shot Station. Try adjusting the angle of the
Remote Commander if you cannot operate the
Cyber-shot Station.
Placing the camera on the
Cyber-shot Station
Remove the Adaptor ring, the Conversion lens,
etc. from the camera.
Attach the camera as shown below.
Be sure to turn off the camera before placing it on
the Cyber-shot Station.
When attaching the camera, make sure to insert
the camera straight down.
Tips
Make sure that the camera is securely attached to
the Cyber-shot Station.





Removing the camera from
the Cyber-shot Station
Hold the Cyber-shot Station down when you
remove the camera from the Cyber-shot Station.
Notes
When removing the camera, make sure to lift the
camera straight up. It may damage the camera or
the Cyber-shot Station when some extra force is
added to the front or the sides.
Charging the battery pack
Place the camera with the battery pack
inserted on the Cyber-shot Station.
Charging starts automatically. The CHARGE lamp
of the Cyber-shot Station lights up.
When the camera is turned on, the Cyber-shot
Station cannot charge the battery pack.
When the charging reaches to Normal charge*,
the CHARGE lamp goes off.
Recording and playback time with Normal
charge is approximately 90% of Full charge.
For the time of the full charge for a completely
discharged battery at the temperature of 25 °C
(77 °F), see the table below.
DSC-T300/T75/T70/T2 Approx.
160 minutes
DSC-
W300/W170/W150//W130/
W125/W120/W115/W110
Approx.
230 minutes
It may take longer to charge, depending on the
charging condition and environment.





*

–