Spalding 214636E - Manual (Page 13)

03/04 P/N 214636E
13
2. Mark pole sections with tape (not supplied) as shown.
6
5
4
3.
WOOD SCRAP
(NOT SUPPLIED)
5
4
While maintaining alignment, bounce middle pole section (5)
into top section (4) using a wood scrap as shown until the
top pole no longer moves toward the taped reference mark
on the middle pole. Upright assembly.
Tape (Not Supplied)
Center
alignment slot
of middle pole
section (5) in a
lower hole of
top pole section
(4) as shown.
IMPORTANT!:
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM) MINIMUM
OVERLAP.
NOTE: