Samsung 570VTFT - Manual (Page 10)

English 8
1 Click on START, SETTINGS, CONTROL PANEL, DISPLAY SETTINGS tab,
ADVANCED, MONITOR tab, CHANGE . This will start the “Add New Hardware
Wizard”.
2 Follow the same directions as given in the steps in the section above.
Windows ® 95
To determine the version of Windows
®
95 that your computer uses, right click on the “My
Computer” icon on the Windows desktop and select “Properties”. The version number can be
seen on the “General” section under “System:”. Follow the directions given below according
to the version of your Windows
®
95 operating system:
Version 4.00.950A
1 Click on START , SETTINGS , CONTROL PANEL , DISPLAY SETTINGS tab,
CHANGE DISPLAY TYPE , CHANGE , HAVE DISK .
2 Type the diskette (or CD) letter in the box and click OK .
Version 4.00.950B
1 Click on START , SETTINGS , CONTROL PANEL , DISPLAY , ADVANCED
PROPERTIES , MONITOR tab, HAVE DISK .
2 Type the diskette (or CD) letter in the box and click OK .
Self-Test Feature Check (STFC)
Your monitor provides a self test feature that allows you to check whether your monitor is
functioning properly. If your monitor and computer are properly connected but the monitor
screen remains dark and the power indicator is blinking, run the monitor self-test by
performing the following steps:
1 Turn off both your computer and the monitor.
2 Unplug the video cable from the back of the computer.
3 Turn on the monitor.
Setting up Your Monitor
570V560V-E3p-28p Page 8 Wednesday, May 9, 2001 9:18 AM