Sony UP-50 - Manual (Page 125)

125 Others
Specifications
Power requirements
UP-51MDP: 220 to 240 V AC,
50/60 Hz
UP-50/51MDU: 100 to 120 V AC,
50/60 Hz
UP-51MD: 100 to 120/220 to 240
V AC, 50/60 Hz
Power consumption
UP-51MDP: About 1.2 A max. at
25°C, 240 V AC
UP-50/51MDU: About 2.8 A max.
at 25°C, 120 V AC
UP-51MD: About 2.8 A max. at
25°C, 120 V AC
About 1.2 A max. at 25°C,
240 V AC
Operating temperature
5°C to 35°C (41°F to 95°F)
Operating humidity
20 % to 80 % (no condensation
allowed)
Storage and transport temperature
–20°C to 60°C (–4°F to 140°F)
Storage and transport humidity
20 % to 90 % (no condensation
allowed)
Dimensions About 370
Ч
125
Ч
490 mm
(w/h/d)
(14
5 ⁄
8
Ч
5
Ч
19 3 ⁄
8
inches)
Mass About 14.5 kg (31 lb 15 oz)
Printing system
Sublimation heat transfer printing
Thermal head 11.6 dot/mm (2048 dots)
Total gradation
256 levels each for yellow,
magenta, and cyan
Printing time Approximately 20 seconds (at
color printing at high speed)
TV system Selectable with the NTSC/PAL
selector (for UP-50/51MD/
51MDP)
In NTSC mode: NTSC/EIA
standards
In PAL mode: PAL B.G.I
standards
Input connectors
RGB SYNC (analog RGB signal):
BNC connector
×
4
RGB: 0.7 Vp-p (75 ohm
termination switch set to ON)
SYNC: 0.3 to 4 Vp-p
SYNC ON G: Automatic
discrimination
75 ohms (75 ohm termination
switch set to ON), sync
negative
S VIDEO (Separate luminance (Y)
and chrominance (C) signals):
4-pin mini-DIN
×
1
Y: 1 Vp-p
C: For NTSC/EIA standards:
0.29 Vp-p color burst
For PAL B.G.I standards:
0.3 Vp-p color burst
75 ohms (terminated), sync
negative
VIDEO (NTSC composite video
signal for NTSC/EIA standards
and PAL composite video
signal for PAL B.G.I
standards): BNC connector
×
1
1 Vp-p, 75 ohms (75 ohm
termination switch set to ON),
sync negative
AC IN (for power input)
Output connectors
RGB SYNC (analog RGB signal):
BNC connector
×
4
RGB: 0.7 Vp-p (75 ohm
termination switch set to ON)
SYNC: 1 Vp-p
75 ohms (terminated), sync
negative
S VIDEO (Separate luminance (Y)
and chrominance (C) signals):
4-pin mini-DIN
×
1
Y: 1 Vp-p
C: For NTSC/EIA standards:
0.29 Vp-p color burst
For PAL B.G.I standards:
0.3 Vp-p color burst
75 ohms (75 ohm termination
switch set to ON), sync
negative