Sony UP-970AD - Manual (Page 9)

Get
ting St
ar
te
d
Paper / Loading Paper in the Unit
9
Paper
Use only Sony UPP-210SE/210HD/UPT-210BL paper
designed for use with this unit. High print quality cannot
be guaranteed if any other paper is used with this unit,
and such paper could damage the unit.
Paper You Can Use
Print paper characteristics are as follows.
Note
The UP-970AD model cannot use UPT-210BL.
Notes on storing and handling paper
Storing unused paper
• Store unused paper at a temperature below 30°C
(86°F) in a dry location that is not exposed to direct
sunlight.
• Do not store unused paper near volatile liquids or
allow the paper to contact any organic volatile liquid,
cellophane tape, or any compound of vinyl chloride.
Loading paper
• Handle the paper carefully when loading to avoid
touching the printing surface with your fingers.
Perspiration or oil from you hands could cause
pictures to blur.
• After removing the label from the leading edge of the
paper, pull the paper out 15~20 cm (about 6~8 in.)
before printing. Label adhesive remaining on the
paper could spoil a picture.
Storing printouts
• To prevent printouts from fading or changing color,
store them in a cool, dry location where the
temperature is not higher than 30°C (86°F).
• Store printouts in a polypropylene pouch or between
sheets of paper that contain no plastic.
• Do not store printouts where they will be exposed to
direct sunlight or high humidity.
• Do not store printouts near volatile liquids or allow the
prints to contact any organic volatile liquid,
cellophane tape, or any compound of vinyl chloride.
• To prevent fading, do not stack printouts on or under a
diazo copy sheet.
• To mount printouts on another sheet of paper, use
double-sides tape or a water base adhesive.
• Do not incinerate waste printer paper.
Loading Paper in the
Unit
Notes
• Do not touch the print surface of thermal printing
paper when loading paper. The fingerprints,
perspiration and creases that may result will lower the
print quality.
• Use only UPP-210 series or UPT-210BL printing
paper (page 9).
• Make the menu settings required by the loaded paper
type (page 17, 30).
1
Press the power ON/OFF switch to turn on the
printer.
The LCD display shows the message “SONY UP-
990AD” for the UP-990AD and “SONY UP-
970AD” for the UP-970AD.
Notes
• The LCD display backlight lights in amber and
shows the message “EMPTY” when no printing
paper is loaded.
• The LCD display backlight lights in amber and
shows the message “DOOR” when the paper door
is open.
• When set to analog mode, the LCD display shows
the message “NOINP” if there is no video signal
input.
Print Characteristics Paper Type
TYPE I (Normal) UPP-210SE
TYPE II (High Density) UPP-210HD
TYPE III (Thermal film) UPT-210BL