Smeg SER63LPG - Manual (Page 15)

Instructions for the user
17
7 USING THE HOB
Before turning on the burners, make sure that the burner rings, caps and
grids have been fitted correctly.
In the ultrarapid burner, notch A must be aligned with pin B.
Grid C provided is intended for use with woks (Chinese pans).
Adapter D comes only with open grids models and is intended for use
with small sized vessels.
7.1 Ignition of the burners
The device is fit with electronic ignition. Simply press and
simultaneously turn the knob counter-clockwise on the low point flame
symbol, until the burner is ignited.
In models with safety valve, the
knob has to be turned to the ignition symbol before it is pressed, and
after ignition the knob has to be kept pressed for about 2 seconds to
keep the flame lit and to activate the safety device.
The burner might go off when the knob is released. In this case repeat
the aforesaid operation keeping the knob pressed for more than 2
seconds.
Should the burners go off accidentally in the models with valves, a
safety device will trip after approximately 20 seconds to block the gas
outlet even if the cock is open.
7.2 Practical advice for using the burners
For better burner performance and minimum gas
consumption, flat bottomed, even pans must be used,
with covers and proportional in size to the burners
(see paragraph “7.3 Diameter of the pans”).
To avoid overcooking or damage to the surface top
while cooking, all pans or griddles must be positioned
within the cooking hob perimeter and must be a
minimum distance of 3-4 cm from the knobs.