Samsung P55 User Manual
Page 89
88
The procedures to connect to an access point using a
wireless LAN configuration program are described. Since
the wireless LAN configuration program is included in
the
system software media, the user has to install the
program.
Atheros Wireless Network Adapter Device
1
Insert the
system software media into the CD drive
and install the wireless LAN configuration program
(PROSet).
Select
System Software Media > User Installation
>
Wireless LAN Driver ReadMe, click ReadMe and
install according to the instructions.
2
Double-click on the wireless LAN program (
) icon
on the taskbar.
Alternatively, click
Start > All Programs > Intel
PROSet Wireless > Intel PROSet Wireless.
3
In Available Networks, click on
Refresh.
4
Select the name of an access point to connect to from
the available network list and click on Connect.
If a network does not appear, click on
Refresh.
5
Enter a WEP key and click the
OK button.
The Wireless Security Settings window may differ
depending on the security settings of the AP.
Click the
Advanced button to set up network
authentication, data encryption, etc. For more security
setting information, ask your wireless network
administrator.
Refer to setting up the advanced settings by clicking on
the
Advanced button.
■
Network authentication: The network authentication
options include an Open System and Shared Key.
When selecting Open Systems, no authentication
is applied (however, encryption is supported).
When selecting Shared Key, a WEP key is used for
authentication. The default setting is Open System.
■
Data encryption (WEP): The IEEE 802.11 WEP
(Wired Equivalent Privacy) standard defines two
levels of encryption, a 64-bit key (this is sometimes
represented by 40bits) and a 128-bit key.
■
Key index: Select the current encryption key index
used by the access point out of 1 to 4.
■
Using an encryption key: Click Use pass phrase
to activate, and enter 5 (for 64- bit) or 13 (for 128-bit)
alphanumeric characters (represented by 0-9, a-z, or
A-Z).
6
The Done window appears, click
OK.
When a wireless connection to an access point is
established, the connection icon (
) appears in
front of the name of the connected profile.
Wireless Network Setup Using the Wireless LAN Setup Program