Kodak SRP 30 - Manual (Page 257)

Operator’s Guide
Daily Weekly Monthly When
required
Maintenance jobs to be performed by the customer
x Clean air filters
– Lamp house
– CCD fan
– Below cutter units
– Door to print engine
– Paper processor: Right side wall, dryer, and AC
supply
x Change scan lamp (service life approx. 300 hr)
x Change chemical filters
x Clean processing racks
x Clean dryer rack
x Clean paper outlet PO:
– Clean / replace air filter
– Clean slide plate with feed chute
– Clean rubber transport belts
x Remove dust from lens
x Replace all air filters with the Annual Air Filter Kit
x Change back printer ink ribbon
x Empty effluent tanks
WARNING: Observe the safety precautions on all equipment labels and in
the Regulatory and Safety section of this manual.
Do not clean while power is applied to the paper processor
drive.
To prevent injury when working in the printer area, avoid
contact with the toothed belts and any sharp corners or edges.
8-4 KODAK PROFESSIONAL SRP 30 Laser Printer