Kodak A-61557 - Manual (Page 23)

A-61557 December 2006 21
3 Using the Scanner
Turning the scanner
on and off
• Toggle the power switch on the back of the scanner to turn the
scanner on or off.
After you turn on the scanner, wait for it to complete the self-test. When
completed, the red LED will remain on and constant.
NOTE: Once your application has detected the scanner, the red LED
will change to green. If checks are in the input tray, the Paper
Detect (left LED) will illuminate.
Document
preparation
• For i6060 and i6090 Scanners only. A batch of documents to be fed
into the scanner must be arranged so the bottom and left leading
edges of all documents are aligned in the automatic feeder; this
allows the feeder to introduce documents into the scanner one at a
time.
• Remove all staples, rubber bands and paper clips, etc. before
scanning.
• Documents should be in good condition.
• If your documents are very flat and smooth, it may be necessary to
loosen the documents by bending them back and forth several times
to help loosen and separate them.
Paper Weights: 60 to 120 g/m 2 (16 to 32 lbs.)
Document Size:
• Height: 54 to 106 mm (2.12 to 4.17 in.)
• Length: 99 to 228 mm (3.91 to 8.97 in.)
Paper inks: All inks on the paper must be dry before scanning is
started. This includes: Standard offset printing, Inkjet printer, Thermal
transfer, Handwriting inks.
Correction Fluids : All correction fluids on the paper must be dry before
scanning is started. This includes: Liquid Paper®, Tipp-Ex®, Wite-out®,
and other similar correction fluids.