Kodak A-61557 - Manual (Page 25)

A-61557 December 2006 23
4 Maintenance
Supplies and
consumables
Contact your scanner supplier to order additional supplies:
Cleaning the scanner
Cleaning will depend upon how frequently your scanner is used. It is
usually needed after scanning 3,000 to 5,000 documents. Ink from
scanned checks can build up on the drive rollers as well as dust, lint
and small particles can get into the track area between the front and
rear scan heads. It is recommended that you clean your scanner at
regular intervals based upon the number of documents scanned. This
could be as often as once a day. Every fourth cleaning cycle, it is
recommended to use the cleaning swabs on the four main drive rollers,
and do a weekly/monthly cleaning procedure as described later in this
chapter.
NOTES:
• Cleaning frequency can be reduced if you allow the ink on the check
to completely dry before scanning.
• Videos demonstrating proper cleaning techniques can be found on
the PC, under Start>Programs>Kodak, if the installation CD that
came in the Welcome Folio has been run.
Daily cleaning
procedures 1. Launch the Kodak ScanTest Software.
2. Open the cleaning card package and remove the cleaning card.
3. Place the cleaning card between the entry separation drive roller as
shown.
Description CAT No.
Cleaning Kit / Kodak i6000 Series Check Scanners
(including cleaning cards and swabs) 802 7393
Inkjet Cartridge hp c6602a 830 1087