Kambrook KOT700 - Manual (Page 12)

12
Preheat the Multi Oven to 200°c with the
element selector switch selecting both
elements, place the wire rack in the
middle position
Remove the ribs and place them in a single
layer in a ovenproof ceramic dish.
Mix all the ingredients for the marinade in
a large bowl until well combined.
Pour the marinade over the ribs and
ensure all the ribs are coated in the
marinade.
Place the ribs into the Multi Oven; cook
for 45 minutes turning the ribs every
15 minutes.
The ribs may take longer to cook
depending on how thick they are.
Serving suggestions:
Serve with steamed rice, a salad or grilled
vegetables.
Roast beef
Serves 4
1 kg beef (scotch fillet or boned rib)
2 cloves of garlic
Freshly ground pepper
2 tablespoons red wine
2 tablespoons plain flour
2 cups of beef stock
2 tablespoons peanut oil
Remove all trays from the Multi Oven.
Preheat the Multi Oven to 210°c with the
element selector switch selecting both
elements, place the wire rack in the
bottom rack position.
Slice the garlic into matchsticks, make
small incisions into the beef and place the
garlic into them, grind some pepper onto
the beef and rub with the oil, place onto
the roasting tray.
Place the beef into the Multi Oven; cook
1 hour for medium or 1
1 ⁄
2
hours for well
done.
After the beef is cooked remove it from
the Multi Oven and let it rest for 15
minutes, covered in foil.
Mix the red wine and flour together in
a small saucepan, place on the hotplate set
to setting 3 and add the beef stock and
the juices from the resting meat. Cook
stirring constantly until the gravy thickens.
Slice the meat and serve with the gravy.
Serving suggestion:
Serve with baked vegetables.
Roast leg of lamb
Serves 4
1.5 kg leg of lamb 2 garlic cloves
3 sprigs of rosemary
2 tablespoons of olive oil
Salt and ground pepper
Fresh mint sauce
1 ⁄
4
cup of castor sugar
3 ⁄
4
cup of fresh mint leaves chopped
1 cup of malt vinegar
Remove all trays from the Multi Oven
apart from the element protection tray.
Preheat the Multi Oven to 210°c with the
element selector switch selecting both
elements, place the wire rack in the
bottom rack position.