KORG TONEWORKS AX5B - Manual (Page 12)

12
4. Advance the expression pedal forward to the position where the ef-
fect should turn on/off.
Advance pedal
5. Take your foot off the expression pedal while it’s still advanced forward.
6. The pedal will return by itself when you remove your foot. When the pedal
has returned by itself, press the [
▲ (WRITE)] button. The display will indi-
cate “ ”(Complete) and the sensitivity will be adjusted. After the display
has indicated “ ” the AX5B will automatically switch to Program mode.
If you decide not to carry out this adjustment, press the [ ▼ (CANCEL)] switch.
Restoring the factory preset programs
Here’s how to restore (reload) the AX5B’s programs back to factory pre-
set programs.
When you execute this operation, all the programs you created and stored
inside the AX5B will be erased, and replaced by the factory programs.
1. While holding down both the Program Up and Down switches as
well as the [
▼ (CANCEL)] button, turn on the power. Continue hold-
ing down the pedal and switch until the program/value display indi-
cates “
”(Reload).
2. Release your hand from the switches you were pressing.
3. If you wish to reload the factory settings press the [ ▲ (WRITE)] but-
ton. The program/value display will indicate “ ”(Load) and reload-
ing will begin. When reloading is completed, the program/value dis-
play will indicate “
”, and the AX5B will automatically enter Pro-
gram mode.
You can’t cancel the reload operation once you’ve pressed the [ ▲
(WRITE) ] button.
Never turn off the power while reloading.
If you decide to cancel the reload operation, press the [ ▼ (CANCEL)]
button while the program/value display indicates “ ”.
Troubleshooting
If you suspect a malfunction, please check the following points. If this
does not resolve the problem, please contact a nearby dealer.
1. Power does not turn on
❑ Have the batteries have run down? When the batteries run low,
the display will blink “
”. We recommend that you replace the
batteries as soon as possible. If batteries become unusable, re-
move them immediately. Leaving drained batteries in the unit can
cause malfunctions such as battery leakage. You should also re-
move the batteries if you won’t be using the AX5B for an ex-
tended time.
❑ Have you have inserted a stereo cable into the INPUT jack?
When operating the AX5B on batteries, the power will not turn
on if you insert a stereo cable. Be sure to use a mono cable.
❑ Is the AC adapter connected to the rear panel DC9V jack?
❑ Is the AC adapter plugged into an AC outlet?
❑ Could the AC adapter be damaged?