Kodak 3000DSV-E - Manual (Page 33)

3-10 A-61371 September 2004
Correcting a number
To reset an entry:
• Press the Clear/Stop key, which resets the number on the Multi-Print
display to “1”.
Using Auto Masking
The Auto Masking function prevents the frame (non-image area) of a
film image from appearing on the print.
Selecting Auto Masking
• Press the Auto Masking key to turn on this function.
Operating Conditions for Auto Masking
• The image area of the screen must provide at least 45 mm
horizontally and vertically.
• The width of the frame to be masked must be at least 10 mm.
NOTE: If the film image on the screen does not meet the above
requirements, the Auto Masking function will not work properly.
Auto Masking is a frame erasing feature, it cannot remove an
image from in between two separate frames.
Correction
B
B
B B
A
A
A B A C