Preparation section, Before applying power, Safety precautions – Kenwood HM-335 User Manual

Page 2: Factory fitted moulded mains plug, Ac voltage selection, The marking of products using lasers

Advertising
background image

Before applying power

2

EN

Units are designed for operation as follows.

U.S.A. and Canada ............................... AC 120 V only

Australia .............................................. AC 240 V only

Europe and U.K. ................................... AC 230 V only

For the United Kingdom

Factory fitted moulded mains plug

1. The mains plug contains a fuse. For replacement, use

only a 13-Amp ASTA-approved (BS1362) fuse.

2. The fuse cover must be refitted when replacing the

fuse in the moulded plug.

3. Do not cut off the mains plug from this equipment. If

the plug fitted is not suitable for the power points in
your home or the cable is too short to reach a power
point, then obtain an appropriate safety approved ex-
tension lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off, remove the
fuse and dispose of the plug immediately, to avoid a
possible shock hazard by inadvertent connection to
the mains supply.

IMPORTANT : The wires in the mains lead are coloured

in accordance with the following code:

Blue

: Neutral

Brown : Live

Do not connect those leads to the earth terminal of a
three-pin plug.

China and Russia ................................. AC 220 V only

Other countries ................... AC 110-120 / 220-240 V

switchable*

Safety precautions

WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EX-
POSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT RE-
MOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

RISK OF ELECTRIC SHOCK

DO NOT OPEN

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS IN-
TENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN
THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF
ELECTRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE
USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUC-
TIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.

CAUTION

Before applying power

Caution : Read this page carefully to ensure safe operation.

* AC voltage selection

The AC voltage selector switches on the rear panel are
set to the voltage that prevails in the area to which the
unit is shipped. Before connecting the power cord to
your AC outlet, make sure that the setting positions of
these switches match your line voltage. If not, they
must be set to your voltage in accordance with the fol-
lowing direction.

AC voltage selector switches

Move switch lever to match your line voltage

with a small screwdriver or other pointed tool.

Note : Our warranty does not cover damage caused by
excessive line voltage due to improper setting of the AC
voltage selector switch.

The marking of products using lasers

(For countries other than U.S.A., U.S.-Military and Canada)

The marking of this product has been classified as Class 1. It means
that there is no danger of hazardous radiation outside the product.

Location: Back panel

CLASS 1

LASER PRODUCT

CAUTION

VISIBLE LASER RADIATION
WHEN OPEN. DO NOT STARE
INTO BEAM OR VIEW DIRECTLY
WITH OPTICAL INSTRUMENTS.

Inside this laser product, a laser diode classified as Class 3A laser
radiation is contained as alerted by the internal caution label shown
above. Do not stare into beam or view directly with optical instruments.
Location: CD laser pick-up unit cover inside this product

VOLTAGE SELECTOR

110V/220V

Advertising