Kyocera K122 - Manual (Page 19)

User Guide for the Kyocera K122 Phone 11
– When no svc alerts you with three tones
decreasing in pitch when service is lost
and three tones increasing in pitch when
service is acquired again.
– Roam Change alerts you with two
decreasing tones when roaming service is
acquired and three increasing tones when
home area service is acquired again.
– Any Change alerts you with three
increasing tones if there is a change in
roaming service or three decreasing tones
if the phone loses service.
Setting the roam ringer
You can set a ringer to indicate when an incoming
call will be subject to roaming charges.
1. Select Menu → Settings → Sounds →
Roam Ringer .
2. Highlight Enabled to hear the ringer.
3. Press to set.
Setting Call Guard to avoid
roaming calls
You can set the phone to warn you before you
answer or place a call while roaming.
• Select
Menu → Settings → Convenience →
Call Guard → Call prompt .
– The phone now emits a distinctive roam
alert to indicate when you are roaming
during calls.
– To accept or place a call while roaming,
you must press .
Note: This functionality is disabled when the
phone is in emergency mode.
Turning roaming on or off
This setting allows you to control the phone’s
roaming feature by specifying which signals the
phone will accept.
1. Select Menu → Settings → Network →
Roam Option .
2. Select an option and press .
– Automatic (recommended setting)
accepts any system the phone
service provides.
– No roaming prevents you from making
or receiving calls outside of your home
service area.
Note: If your phone has more than one setting for
Automatic, contact your service provider to
determine which one to use.
82-G1675-1EN.book Page 11 Tuesday, September 12, 2006 2:50 PM