Kyocera K122 - Manual (Page 9)

User Guide for the Kyocera K122 Phone 1
1 G
ETTING
S
TARTED
Installing the battery
Your phone comes with a removable lithium ion
(LiIon) battery.
1. Hold the phone with
the back facing you.
2. Unsnap the battery
door by using the latch
located at the bottom
of the battery door.
3. Place the battery in the
phone casing with the
metal contacts toward
the bottom of the
phone.
4. Place the battery door
tabs in the openings
on
the side of the phone.
5. Press the battery
door until it snaps
into place.
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls. Fully charge the
battery before using the phone.
To charge the battery,
connect the AC adapter to the
jack on the bottom of the
phone, then plug the adapter
into a wall outlet.
The battery icon in the upper-right corner of the
screen tells you whether the phone is:
• Charging (the icon is animated)
• Partially charged
• Fully charged
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
Caring for the battery
General safety guidelines
• Do not take apart, puncture, or short-circuit
the battery.
• If you have not used the battery for more than
a month, recharge it before using your phone.
• Avoid exposing the battery to extreme
temperatures, direct sunlight, or
high humidity.
• Never dispose of any battery in or near a
fire – it could explode.
82-G1675-1EN.book Page 1 Tuesday, September 12, 2006 2:50 PM