Kunz MR44K - Manual (Page 11)

The cutting height can be adjusted in a range from 2.0" to 8.0". This is accomplished by turning
the he
to raise ckwise to lower the mower cutting height.
llow easier pivoting. Care should be taken not to loosen too much or excess wear and
The adjustment crank may unturn due to vibration. This will allow the mower’s cutting height to
change. The crank can b
ustment nut tube and the
height adjust support. See Figure 9.
Figure 9: Securing Crank While Not In Use
ight adjust crank located at the back of the mower. See Figure 8. Turn the crank clockwise
the mower cutting height and counter-clo
DANGER: Shut off tow vehicle engine and allow mower blades to stop completely before
Adj
1.
2. The desired cutting height can be determined by measuring the distance from the ground to
e
is 1-5/1
Note:
t screw may be too tight. Loosen the pivot bolts slightly to
attempting to measure the cutting height.
ust the mower as follows:
Pull the mower on to a smooth, level surface.
the outside lower edge of the mower deck and adding 1-5/16”. The mower blade cutting edg
6” above the outside lower edge of the mower deck.
If the height adjust crank does not turn easily, the pivot bolts holding the carrier arm
assemblies and height adjus
a
flexing may occur. Greasing the threads on the height adjust screw may also allow
greater ease in adjustment.
Note: After setting the initial cutting height, quick field adjustments can be completed by
counting crank turns. Roughly 8 turns will equal 1” of vertical movement.
e secured by folding it down between the adj
Adjustment Crank
Height Adjust Support
Adjustment Nut Tube
10