Kunz MR44K User Manual
Page 14
F. DRIVE B
Refer to Figure 10
: Shut off engine and allow mower blades to stop turning before making any
Remove the safety shields.
Loosen the nuts on the spring-loaded idler; adjust bolt until the belt can be slipped off the idler and
Slip the belt down under the drive sheave and off the blade spindle sheaves.
Install the new
pecial care to
make sure that the belt is placed between the brake stud and the idler pulley.
Slip the belt down under the drive sheave and off the blade spindle sheaves.
Install the new
pecial care to
make sure that the belt is placed between the brake stud and the idler pulley.
E
WARNING
LT REMOVAL AND TENSION –
adjustments or repairs.
drive sheaves.
belt and then adjust the tension as follows: See Figure 10. Take s
belt and then adjust the tension as follows: See Figure 10. Take s
No Less Than 1/2” Clearance With
Clutch Engaged
0” With Clutch Disengaged
Brake Stud
Clutch Engaged
Spring Length 2-3/4”
to 3-1/4”
Clutch Disengaged
Spring Length 3-1/4”
to 4”
Clutch Arm
Engine
Front Clutch
Engagement
Only Include
Spring in
Measurement
Figure 10: Belt Pattern, Spring Adjustment, and Brake Adjustment
Figure 10: Belt Pattern, Spring Adjustment, and Brake Adjustment
13