Kunz MR44K - Manual (Page 12)

C. STARTING ENGINE
WARNING: Set parking brake on tow vehicle.
Attach mower tongue to tow vehicle.
WARNING: Do not start rough cut mower unless it is attached to the tow vehicle.
n fuel shut off valve which is located on the underside of the gas tank.
Set the choke to the desired position.
Set the throttle at approximately half throttle.
Set
clutch han
ont of the mower under the engine.)
Not
ne di s while in use, remove the rough cut mower from the
uncut area before attempting to engage the clutch. Inspect the blades for any obstructions
gement. Failure to follow these instructions may result in
premature belt failure or a fire.
Adjust engine speed to full throttle.
D. SHUTTING OFF ROUGH CUT MOWER
WARNING: Shift to neutral and set the parking brake before dismounting the tow vehicle.
he engine speed down to an idle and slowly disengage the clutch handle.
Allow engine to cool down for a short time before moving the ignition switch to the off position.
Turn off fuel shut off valve which is located on the underside of the gas tank.
. MOWER OPERATION
DANGER: Keep hands, feet, hair and clothing away from moving parts.
Clean or replace any safety signs that are not readable or damaged.
Turn o
Start engine and allow engine to warm up.
engine speed at about half throttle and slowly engage mower blades clutch handle. (The
dle is located at the fr
e: Some belt squealing may occur on engagement. This is normal for a manual clutch
engagement design.
CAUTION: If the mower’s engi e
that may prevent blade enga
Slow t
E
CAUTION:
11