Kenwood XD-A75 XD-A55 - Manual (Page 23)

23 EN
Dubbing from tape to tape
1
Press the POWER / ON/STANDBY button to turn
the power on.
2
Load a pre-recorded cassette into the TAPE A
cassette compartment. Insert a blank tape into
the TAPE B cassette compartment.
• It is recommended that the recording tape be
the same length as the master tape.
3
Press the TAPE (A/B) button until “TAPE A” ap-
pears in the display.
4
Press the REC PAUSE button.
“REC.” and “ ¶ 3” will flash.
5
Press the 3 button.
“REC.” will disappear and “ ¶ 3” will light up.
To stop dubbing :
Press the 7 STOP button.
• TAPE A and TAPE B will simultaneously stop.
Erasing recorded tapes
• Make sure that TAPE A is not in use.
1
Load the tape to be erased into the TAPE B cas-
sette compartment.
2
Press the TAPE (A/B) button until “TAPE B” ap-
pears in the display.
3
Press the REC PAUSE button.
“ERASE” and “ ¶ 2 3” will flash.
4
Press the 2 or 3 button.
“ERASE” and “ ¶ 2 or ¶ 3” will light up.
1
5
3
4
2
7 STOP
2
3
4
1
Note :
•
When the end of the tape is reached whilst re-
cording, the CD player will display the track
number which was being played at that time,
and stop automatically.
If you want to restart recording from the begin-
ning of the interrupted track, turn over the tape,
press the REC PAUSE button and then the
3
button.
(If tracks have been stored in memory using the
program playback function, recording will restart
from the first track stored in memory.)
Selection of reverse mode :
Press the REVERSE MODE button repeatedly to
select the following setting :
• “ ” ..... Recording stops after having recorded
both sides of tape.
• “ ” ..... Recording stops after having recorded
one side of tape.