Kenwood XD-A75 XD-A55 User Manual

Page 30

Advertising
background image

30

EN

CAUTION

Use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.

In compliance with Federal Regulations, following are reproductions of labeles on, or inside the
product relating to laser product safety.

KENWOOD CORP. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS NO. 21 CFR
1040.10, CHAPTER 1, SUBCHAPTER J.

KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI, TOKYO, JAPAN

Location: Back Panel

For the U.S.A.

For the U.S.A.

FCC WARNING

This equipment may generate or use radio frequency energy. Changes or modifications to this
equipment may cause harmful interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this equipment if an unauthorized change
or modification is made.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment may cause harmful interference to radio
communications, if it is not installed and used in accordance with the instructions. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
– – Reorient or relocate the receiving antenna.
– – Increase the separation between the equipment and receiver.
– – Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

– – Consult the dealer or an experienced radio / TV technician for help.

Note to CATV system installer

This reminder is provided to call the CATV
system installer's attention to Article 820-40
of the NEC that provides guidelines for proper
grounding and, in partiqular, specifies that the
cable ground shall be connected to the
grounding system of the building, as close to
the point of cable entry as practical.

For the U.S.A.

WARNING NOTICE:

In most cases it is an infringement of copy-
right to make copies of tapes or discs with-
out the permission of the copyright owners.
Anyone wishing to copy commercially avail-
able tapes or disc should contact the me-
chanical copyright protection society limited
or the performing rights society limited.

Advertising