KORG D4 - Manual (Page 49)

Operation
47
example, select “1.” Then press the CURSOR [ ] key.
5 Set the “In Time” and “Out Time.”
Use the [VALUE] dial to specify each locate point.
After you’ve specified the locate points, press the
CURSOR [
] key. (Refer to “Copying a track”)
You can press the [PLAY] key to hear approximately two sec-
onds of playback starting at the selected time location.
6 Execute the editing operation.
When the display asks “Ins OK?,” press the CURSOR
[
] key to execute the operation. When the blank space
has been inserted, the display will indicate “Finish!”
7 Press the [PLAY] key to listen to the play back, and
verify that the operation occurred as you intended.
You can press the [UNDO] key to return to the state prior to
executing this operation. (
→p.26)
Erase Track “ErsTrack” — erasing a track
This operation erases any recorded information from the
specified region (In–Out) of a recorded track. When you erase
the region, the data in that region will change to silence.
As an example, here’s how to erase the In–Out region of
track 1.
1 Store the In and Out time locations in the [IN
(LOC1)] key and [OUT (LOC2)] key.
2 Select “TRK EDIT” mode.
Set the [MODE] knob to “TRK EDIT.”
3 Select the Erase operation.
Use the [VALUE] dial to select “ErsTrack,” and press
the CURSOR [
] key.
4 Select “EraseTo” (track number from which you
want to erase data).
Use the [VALUE] dial to select the number of the track
from which you want to erase data. For this example,
select “1.” Then press the CURSOR [
] key.
5 Specify the InTime (“In” time location) and OutTime.
Use the [VALUE] dial to make your selections (see “Copy
Track”). Then press the CURSOR [
] key. To use the
time locations you specified in Step 1, select “LOC 1 (IN)”
as the “In” time and “LOC 2 (OUT)” as the “Out” time.
You can press the [IN (LOC1)] or [OUT (LOC2)] key at this
point to modify the selected time. You can also press the
[PLAY] key to audition the playback for approximately two
seconds starting at the selected time. Modifying the time
here will not affect the time that is registered in the key.
6 Execute the operation.
When the display asks “Ers OK?,” press the CURSOR
[
] key to execute the operation. When the data has
been erased, the display will indicate “Finish!”
7 Press the [PLAY] key to listen to the play back, and
verify that the operation occurred as you intended.
You can press the [UNDO] key to return to the state prior to
executing this operation. (
→p.26)
In Out
Blank
DestTrk
DestTrk