KORG D4 - Manual (Page 51)

Operation
49
1 Store the In and Out time locations in the [IN
(LOC1)] key and [OUT (LOC2)] key. The “To” time
will be set later in this procedure.
2 Select “TRK EDIT” mode.
Set the [MODE] knob to “TRK EDIT.”
3 Select the Expansion/Compression operation.
Use the [VALUE] dial to select “ExpTrack,” and press
the CURSOR [
] key.
4 Select “ExpFrom” (source track number for the data
to be expanded or compressed).
Use the [VALUE] dial to select the number of the track
whose data you want to expand or compress. For this
example, select “1.” Then press the CURSOR [
] key.
5 Select “ExpTo” (destination track number for the
expanded or compressed data).
Use the [VALUE] dial to select the track in which the
expanded/compressed data will be placed. For this
example, select “2.” Then press the CURSOR [
] key.
6 Select “CpyTimes” (number of times the expanded/
compressed data will be copied).
Use the [VALUE] dial to specify the number of times
that the expanded/compressed data will be copied.
For example, select “3.” Then press the CURSOR [
]
key.
7 Specify the InTime (“In” time location) and Out-
Time.
Use the [VALUE] dial to make your selections (see
“Copy Track”). Then press the CURSOR [
] key. To
use the time locations you specified in Step 1, select
“LOC 1 (IN)” as the “In” time and “LOC 2 (OUT)” as
the “Out” time.
You can press the [IN (LOC1)] or [OUT (LOC2)] key at this
point to modify the selected time. You can also press the
[PLAY] key to audition the playback for approximately two
seconds starting at the selected time. Modifying the time
here will not affect the time that is registered in the key.
8 Specify the “ToTime.”
Use the [VALUE] dial to select one of the choices. Then
press the CURSOR [
] key.
You can press the [PUNCH] key at this point to modify the
selected time. You can also press the [PLAY] key to audition
the playback for approximately two seconds starting at the
selected time.
9 Specify the “EndTime.”
Use the [VALUE] dial to select one of the choices. Then
press the CURSOR [
] key.
You can press the [PUNCH] key at this point to modify the
selected time. You can also press the [PLAY] key to audition
the playback for approximately two seconds starting at the
selected time.
0 Select “PitchFix.”
Use the [VALUE] dial to select whether the pitch will
remain the same or will change. For this example,
select “Yes” to fix the pitch. Then press the CURSOR
[
] key.
A Execute the operation.
When the display asks “Exp OK?,” press the CURSOR
[
] key to execute the operation. When the data has
been expanded/compressed, the display will indicate
“Finish!”
B Press the [PLAY] key to listen to the play back, and
verify that the operation occurred as you intended.