Kodak DP1050 - Manual (Page 18)

Contents
18
Volume (+/-)
The Volume key is used to control the sound level
when the KODAK DP1050 ULTRA is connected to an
audio source.
Channel
Click on the arrows left/right to switch between
pre-programmed TV channels when TV is
selected as source.
Brightness
The Brightness key is used to control the brightness in
data and video image.
Contrast
The Contrast key is used to control the contrast in data
and video image.
Stand by
The stand by key will set the KODAK DP1050 ULTRA
in stand by mode. The lamp will turn off, and the fans
will run for a little while cooling the projector before
stopping. To return to normal mode, press the Stand by
key once more, or press the Menu key on the remote
control.
Automatic set-up
The automatic set-up key will set up the projector with
optimal settings for the connected source. If you want
to do manual adjustments you can do this by using the
menus (see section 7).
Note!
You can not access the screen menu
system without the remote control.
6.4 Adjusting the height and angle of
the KODAK DP1050 ULTRA
You can adjust the height and angle of the KODAK
DP1050 ULTRA by adjusting the four small feet under-
neath the product.
NOTE!
The KODAK DP1050 ULTRA should never be left
with an angle of more than 15 degrees over a
longer period of time. This will shorten the
lifetime of the lamp.
1332 (ELEK). KODAK ENG 15.07.98 13:33 Side 18