Kodak DP1050 - Manual (Page 6)

Contents
6
The procedure for connecting a
computer to the KODAK DP1050
ULTRA is the same for all types
of computers.
1. Make sure the computer, monitor and KODAK
DP1050 ULTRA are switched off.
2. Identify the RGB out connector on the back of your
computer (where you connect a monitor to the
computer).
3. Connect the computer to the KODAK DP1050
ULTRA using the EVC cable and the adapter for
the computer you are using. See figures 3 and 4.
4. If you have a desktop computer and want to display
the image on your computer monitor, connect the
cable from your monitor to the adapter.
See figure 5 and 6.
5. If you want to use the remote control to control your
computer, connect the correct mouse cable from
the computer to the adapter box. See figures 7 and
8. When your computer is connected to the KODAK
DP1050 ULTRA with the EVC cable (with EVC con-
nector on the computer), the remote mouse control
will automatically function as a regular mouse on
your PC or MAC.
6. If you want to use sound with your computer,
connect the stereo jack cable to the computer audio
connection and to the PC or MAC adapter box.
7. Turn on the KODAK DP1050 ULTRA and then
the computer. The computer image should now be
projected from the KODAK DP1050 ULTRA and the
remote control should now work as a regular
mouse. If the computer’s image is not displayed
simultaneously on the monitor, or the mouse is not
working, see the section ‘What do I do if’.
3. Connecting a computer to the KODAK DP1050 ULTRA
1332 (ELEK). KODAK ENG 15.07.98 13:33 Side 6