Kodak DCS Pro 14n - Manual (Page 190)

14-4 April 29, 2004
Camera Care
Inspecting and Cleaning the
Imager
CAUTION :
It is important that you follow these instructions when
inspecting and cleaning the imager. Failure to do so can
damage your camera.
1. Turn off the camera.
2. Remove the lens from the camera.
3. Power on your camera using a fully charged battery.
CAUTION :
If the battery loses charge during the cleaning procedure,
the shutter can close and damage your camera.
4. Put the camera in Manual Exposure mode (M). See page 7-15 .
5. Choose Imager Clean from the Tools menu then choose Open.
6. Press the OK button.
The mirror raises and the shutter opens.
7. Visually inspect the imager. If it is dirty, go to
http://www.kodak.com/go/dcspro14n , click "Service and Support",
then navigate to the link for "Cleaning Recommendations for CCD
Coverglass".
8. Choose Imager Clean from the Tools menu then choose Close.
9. Press the OK button.
The shutter closes and the mirror returns.
10. Turn off the camera.
11. Replace the lens.