Kenmore 625.348321 - Manual (Page 5)

WATER SOFTENER START-UP
SECTION 1
5
1B. CHECK LIST OF ALL STEP-BY-STEP GUIDES TO INSTALL
Refer to the Installation Manual, part no.
7159931, for step-by-step guides.
To be sure you have done all the steps to install
the softener, read the following list. Page num-
bers referred to are in the Installation Manual.
n Is the house water flow going INTO the soft-
ener valve INLET? Trace piping to be sure.
See pages 10 and 11.
n
Is the plumbing bypass valve (or 3 valves) set
for SERVICE? Bypass valve(s) should always
remain in soft water service position. Posi-
tion in “bypass” only if needed for softener
repairs. See page 18.
n
Is the valve drain hose connected the right
way, and without sharp bends or kinks that
could stop or reduce water flow? See page 16.
n Is the softener power cable connected to the
transformer, and is the transformer plugged
into an inside, 120V-60Hz electrical outlet?
See page 20.
n
Be sure to restart the water heater. See page
20.
Note, for installations in the State of Massachusetts:
Plumbing codes of Massachusetts shall be adhered to.
Consult with your licensed plumber.
brass
3--valve
plastic
Bypass
Valves
Water
Heater