Karcher KMR 1250 B - Manual (Page 11)

English User Instructions KMR 1250 B
36
Braking
n
Release the drive pedal and the sweeper will brake auto-
matically.
Important note: Safety!
It is possible that the automatic braking function will not be
sufficient to bring the sweeper to a halt. In this case, either
make use of the parking brake as well or gently press the
drive pedal in the opposite direction to travel.
Stopping the sweeper and switching off
n
Release the drive pedal. The sweeper brakes automati-
cally and comes to a halt.
n
Apply the parking brake [ ].
n
Set the throttle lever to minimum engine speed (to the
rear).
n
Make sure the main roller [ ] and side brush [ ]
are raised so that the bristles are not damaged.
n
Switching off
– Turn the ignition key counter-clockwise to the 0 positi-
on and then remove it.
After the engine has been switched off, the filter is
automatically cleaned for approx. 10 seconds.
Cleaning the filter Automatic cleaning
n
Stop the sweeper and switch off the engine.
After the engine has been switched off, the filter is auto-
matically cleaned for approx. 10 seconds.
Manual cleaning
While the sweeper is operating, the filter should be cleaned
approx. every 15–30 minutes (depending on amount of
dust).
n
Stop the sweeper.
n
Set the sweeping mode lever to wet [ ].
n
Briefly operate the filter cleaning button , whereupon
the filter will be cleaned for a duration of approx. 10 secs.
n
Set the sweeping mode lever back to dry [ ].
n
Continue with cleaning task as before.