Konica Minolta 7075 - Manual (Page 20)

1-8 Introduction
Introduction
Features of the Konica 7075 (continued)
• Non STD Size for Multi-Sheet Bypass Tray
Enter the special paper size to be loaded on the Multi-sheet bypass tray using the touch
screen keypad in order to avoid paper misfeed.
• Non STD Size for Original
Identify the special original size which the 7075 could not detect in order to select the
optimal paper size for copying or printing.
• Output mode for Machine with FS-108/108B Finisher Installed:
Non-Sort, Sort, Staple-Sort, and Group modes using the primary (main) tray
Non-Sort Face Down exit, Non-Sort Face Up exit, Group Face Down exit, and
Group Face Up exit modes using the secondary (sub) tray
Stapling & Folding, and Folding modes using the booklet tray (FS-108B only)
Select an output tray and output mode on the Finisher Mode Selection Screen and on
the Control panel. For details of each output mode, see Section 7: Output Modes.
• Output for Machine with no Finisher Installed: Sort and Group modes
Use the default condition to output copies in the same order as the originals. Use the
Sort mode to alternately switch the horizontal and vertical orientation of each copied set
upon exit. Use the Group mode to output multiple copies of each original without
offsetting them upon exit.
• Output mode for FS-108/108B Finisher with PI-108 Cover Sheet Feeder Installed:
Cover Sheet mode
Manual Staple mode
For details of each output mode, see Section 7: Output Modes.
• Paper Capacity
Total 2,150 sheets, including two 500-sheet trays, a 1,000-sheet tray, and a 150-sheet
Multi Sheet Bypass tray.
Total 6,150 sheets, including 4,000-sheet optional large capacity tray.
• Platen Memory
Scan documents into memory from the platen glass and/or the document feeder and
insert the pages into another document copied from the document feeder. If an
incompatible function is selected in this mode, the latter function will not be selected, and
a Caution message will be displayed.
• Power Saver
Automatically turns off all but nominal power supply after a specified period of copier
inactivity, for optimal efficiency. Power is returned after a brief warm up period by
pressing [
POWER SAVER ON/OFF ] key on the Control panel.