KTI Networks KS-2260 - Manual (Page 103)

-103-
Auto Negotiation : Display the auto negotiation mode setting and status
Config / Atual
Auto = enable auto negotiation with the specified highest capability
Force = disable auto negotiation and use forced mode
Nway-force = enable auto negotiation with the specified capability
Note : Specified capability means speed and duplex configuration
Speed status : Display port speed setting and status
Config : port speed capability setting
Atual : port speed is used currently
Port 1-24 : 10/100Mbps
G1 port, G2 port : 10/100/1000Mbps
Duplex status : Display duplex setting and status
Config : port duplex capability setting - Full, Half
Atual : port duplex mode is used currently - Full, Half
Flow Control: Display the flow control settings and status
Config/Full : On = enable for full duplex, Off = disable
Config/Half : On = enable for half duplex, Off = disable
Atual : current flow control status
Rate Control : Display the port rate control settings (unit=100K bytes)
Atual/Ingr : Display the port effective ingress rate setting
Atual/Egr : Display the port effective egress rate setting
Off = the rate control is disabled.
Priority : Display the port port-based priority setting
High = the port is high priority port.
Low = the port is low priority port.
Disable = port-based priority is disabled.
Port Security : Display the port security setting (SA MAC learning)
On = security on and SA MAC address learning is stopped
Off = port security off and performs normal MAC address learning
Note : SA = Source MAC address in the received packet