K-Tec HP3A User Manual

Page 13

Advertising
background image

HP-10

SECTION 7

TROUBLESHOOTING

7.1 BLENDER MOTOR WILL NOT TURN ON

If the blender motor will not turn on, try the following:

• Make sure the main power switch on the back lower-right corner is turned

ON.

• Check your house circuit breaker switch or fuse, to make sure it is set to the

ON position.

• Unplug the power cord from the wall receptacle, wait 5 seconds, then plug

power cord back in.

• Determine if the Liquid Crystal Display (LCD) is lit. An absence of a lit LCD

indicates a lack of power to the unit.

• Remove the blender jar from the blender motor and check to make sure the

blade turns freely while unattached to the motor. If the blade does not move

freely the problem may be the jar, not the motor. Check the jar by turning the

shaft by hand to see if it rotates easily.

Look at the LCD:

• A reading of “OVERTEMP” indicates that the motor is overheating. The

blender has been disabled until the unit cools to operating temperatures.

Turn off and unplug the unit. Allow it to cool for at least 20 minutes.

• A reading of “OVERLOAD” indicates an overload on the motor. Turn off

and unplug the unit. Plug in the unit and turn the motor on again to clear the

over-load condition. Check the blender jar for blockage. If overload condi-

tion re-occurs, contact your Blendtec service agent.

• BLADE STOPS: If the overload switch stops the blender, remove the blender

jar and carefully check for blockage of the blade. If no blockage is found,

replace jar and use the Pulse button on the touch pad to quickly pulse the

blade through the mixture. Once the blade spins freely a programmed but-

ton may be used.

7.2 NOISE LEVEL CHANGES

If the blender noise level has increased significantly from original levels, deter-

mine whether the sound is coming from the blender motor or jar.

• Blender Motor: Check to see if the excess noise is coming from the blender

base. Remove the jar and press cycle number two or three. Listen to the

motor sound without a jar attached. If it is excessively noisy contact your

Blendtec service center.

• Jar: Check to see if the excess noise is coming from the jar. Place the jar

back on the motor. Run the motor for a few seconds using the Pulse button.

If you have more than one jar, test a different jar to determine whether the

sound changes as different jars are used. If a jar is excessively noisy, or if

the blade assembly seems loose or sounds “gravelly” when turned by hand,

contact your Blendtec service center.

Advertising