KVH Industries LF - Manual (Page 2)

1 54-0194 Addendum to Rev. D
TracVision LF/SF Owner’s
Manual Addendum
(ECO # 6857)
The following information applies to Revision D of the
TracVision LF/SF Owner’s Manual (KVH Part Number 54-0194).
The DISH 500 mode, in which the SAT SELECT button switches
between the two DISH 500 satellites, has been changed to make it easier
to use. The following instructions have been updated to reflect this
change.
3.5 DISH 500 Operation
The DISH 500 service offers programming on two different
satellites (Echo 119 and 110). To easily switch between these two
satellites, you will need to configure the system for DISH 500
mode, in which the SAT SELECT button selects between just the
Echo 119 and 110 satellites.
3.5.1 Configuring the System for
DISH 500 Mode
To configure the TracVision system for DISH 500, follow the steps
below.
1. Turn on your receiver, TV, and TracVision
system.
2. Using the receiver’s remote control, go to the
“Point Dish/Signal Strength” screen (press MENU,
6, 1, 1 (on most models)) and select satellite 119 and
transponder 11.
3. When the switchplate’s Status indicator fully
illuminates (stops flashing), check the signal
strength meter on the TV. If the meter turns green
and indicates “Locked–Echostar 119,” skip to
step 6.
N E T W O R K