Kenwood R-K701 - Manual (Page 41)

ENGLISH
41 EN
Timer operation
7
Put the unit in standby mode.
Press the (POWER) key.
÷ When the unit enters the Standby mode, the
STANDBY/TIMER indicator lights in green.
÷ If there is a power failure or the AC power cord is
unplugged after the timer reservation has been
activated, the STANDBY/TIMER indicator blinks in
green. In this case, the clock setting should be
restarted from the beginning.
÷ Active timer program can be seen on the display by
pressing the 7(STOP) key.
Deactivating and activating the timer program
Once the timer setting procedure has been performed, the timer program can be deactivated or activated easily.
When the unit is in on, press the TIMER key.
TIMER
or
Each press of the TIMER key changes the items ;
1 Activate PROG.1 timer.
2 Activate PROG.2 timer.
1, 2 Activate both PROG.1 and PROG.2
timer.
Deactivate the timer. (Timer indicator is off.)
÷ The timer program contents remain even if the timer is
deactivated.
÷ After a power failure or the AC power cord has been
unplugged, the STANDBY/TIMER indicator blinks in
green. In this case, set the present time, and then go
through the timer setting procedure again.
04.12.16, 0:23 PM 41