Lubrication, Lubrication locations, Lubrication locations 3115 – Kuhn Rikon 3100 User Manual
Page 28
3100ST 006046 010507
ALWAYS STOP MIXER AND DISCONNECT POWER BEFORE SERVICING, REPAIRING OR
CLEANING. USE SAFE SHOP PROCEDURES AND EXERCISE CAUTION WHEN WORKING ON
THIS MIXER!
It is extremely important that the following lubrication guide be followed:
For lubricating bearings, use a good quality multipurpose grease. Replace all damaged or missing grease
zerks immediately. Always clean zerks before using grease gun. Pump the grease in slowly until a slight bead
forms around the bearing seals. Once a month check lines and connections on grease banks for leaks.
Before operating a new mixer, the roller chains should be liberally lubricated and then the unit operated
under a no-load condition. This break-in period will allow the roller chains to be thoroughly lubricated and thus
minimize heat-up during operation.
The large drive enclosure is designed to be used as an oil bath. Fill front enclosure until the oil level reaches
the plug labeled “oil level ”on the enclosure.
LUBRICATION
LUBRICATION LOCATIONS
3115
* * * shields removed for illustrative purposes