Kreisen 3 8 6 X / X E - Manual (Page 47)

1. The BIOS to use 100 bytes at 30h:O
2. The BIOS to reduce the size of the base memory by 1KB.
The default is 1. If you are not using Drive type 47 or not
running programs like OS/2, RAMDRIVE this RAM will
never be used by so you may leave the value as 1.
Leaving the CMOS Setup
When you have completed the changes, press the < ESC >
key. The SETUP program will display the message:
Write data into CMOS and exit (Y/N)?
If you have made any mistakes, press N for No, then move the
cursor back up to the beginning and verify each parameter,
making any corrections necessary. When you are satisfied with
the option settings, press the < ESC > key, then press Y to
write the new settings into the configuration RAM. Your
computer will run through the self test diagnostics again and
try to read a diskette in the first floppy disk drive.
As mentioned above, you may see an error message if you don’t
have a system diskette inserted into the floppy disk drive.
Extended CMOS SETUP
The Extended CMOS Setup program can be used to program
the Chipset Extended CMOS with user defined values which
will be used by the BIOS to program the Chipset registers
during system boot up.
To enter the Extended CMOS SETUP program, set the reverse
video cursor on the “RUN XCMOS SETUP” using Up and
Down arrow key and press < ENTER> on the following
message.
2-10 Running the Setup Program