T-42 – Konica Minolta PagePro 1390 MF User Manual
Page 152
T-42
xxxx62
DCN
received
• Received Disconnect
command (DCN) from
other side at Phase D.
• Failure in
machine of TX
side
• Check the status
of the machine
of TX side
xxxx63
Too many
CRP
• Received Command
Repeat (CRP) from other
side more than 3 times
after sending (PPS-) Q
Command.
• Line failure
• Retry TX
xxxx64
Too many
PPR
• Received Failure to Train
(FTT) from other side
even with the minimum
speed of 2400 bps.
• Line failure
• Retry TX
xxxx65
RNR time
Out
• Other side was not in RX
mode within 60 seconds
in Flow Control.
• Failure in
remote machine
• Check the status
of the remote
machine
xxxx66
RTN/PIN
Received
• Received Negative
response from other side
for Q Command.
• Line failure
• Retry TX
Comm. Error (at Phase-E)
xxxx70
Time Out
• Did not receive DCN
within 6 seconds at Phase
E.
• Failure in
remote machine
• Line failure
• Check the status
of the remote
machine
• Retry TX
Code
Status
Description
Cause
Action