Kompernass KH 6504 - Manual (Page 14)

- 12 -
Playback of an external devices audio and
video signals with the DVD player
You can playback images and sound from an
external device via the DVD player.
1. For sound transmissions insert the audio cinch
cable's red jack plug into the
AUDIO IN/OUT COAX
socket of the DVD player.
2. Insert the white and red cinch plugs of the
audio cinch cable into the corresponding
audio output of the external device.
3. Insert the video cable's yellow jack plug into
the
VIDEO IN/OUT socket of the DVD player.
4. Connect the cinch socket of the video cinch
cable with the corresponding video output of
the external device.
5. Switch on the DVD player and the external
device.
6. In order to playback the external device's
audio and video signals press the
AV button
on the remote control.
7. In order to switch back to the DVD player's
display press the
DVD/USB/CARD button.
Note:
Depending on the data carrier the display can
remain black for a few seconds until the DVD
players image is again displayed.
Note:
The sound of an external device connected to
the DVD players audio input will also playback
if the device is set to an operating mode other
than AV.
6.4 Connecting the antenna
For reception of an analogue TV signal the DVD
player must have an antenna connected to it.
This can be achieved by connecting to your house
antenna via an antenna cable or with the supplied
wand antenna.
Connecting the wand antenna
1. Insert the plug of the supplied wand antenna
into the
ANT socket on the side of the DVD
player.
2. For mobile operation place the wand antenna
close to the DVD player.
IB_KH6504_V865_LB6_V2 24.01.2008 18:26 Uhr Seite 12