Kompernass KH 6504 - Manual (Page 34)

- 32 -
CHROMA
Here you set the television standard PAL or
SECAM. In the AUTO setting the television standard
is set automatically.
SKIP
•
With the control buttons tuned the skip
function to ON to skip over the currently tuned
station so that by interconnection of the station
it will no longer be displayed.
• To show the station again, in the function
POSITION insert the corresponding station
and subsequently set the skip function to OFF.
FINE
Press the control buttons
repeatedly to fine tune
the frequency for the currently indicated channel
backwards or forwards.
AUTO-SEARCH
•
Select this input and press the control button
to start an automatic station search.
Note:
Before starting a station search make sure that
you have connected the system to an antenna
correctly as described in section 6.4 Connec-
ting an antenna.
Thereby the stations found will be filed, one after
the other, in the programme cells.
After the end of the search the first found station on
programme cell 01 will playback.
•
To cancel the search press the control button
.
SEARCH
•
In the function POSITION set the station, on who-
se programme cell you want to start a search.
• Select the input SEARCH and press the control
buttons
to start a manual station search
backwards or forwards.
The station search stops at the first found station.
Button functions in the TV mode
Fine tuning
• During the TV playback press the SLOW/FINE
button. The currently tuned frequency appears
in the right top corner of the display.
• With the buttons PREV DOWN / NEXT UP on
the remote control and/or PREV/NEXT /
or
/
on the device you can now fine tune the
frequency backwards or forwards.
Programming stations
• Tune to the desired station frequency and then
press the
REV / MEM button.
• The channel number in the right top corner
of the display is shown in red.
• With the number buttons enter the desired
station channel number.
• Press the REV / MEM button again. The channel
number is now green and the station is saved in
the memory cell.
Automatic search function
• Hold one of the buttons PREV DOWN / NEXT UP
on the remote control and/or PREV/NEXT /
or /
on the device down for about 2 se-
conds during the TV playback to start an auto-
matic station search backwards/forwards.
• The search starts immediately from the currently
playing back frequency.
• To cancel the search hold down one of the but-
tons
PREV DOWN / NEXT UP on the remote con-
trol and/or PREV/NEXT /
or / on the
device again for about 2 seconds.
IB_KH6504_V865_LB6_V2 24.01.2008 18:27 Uhr Seite 32