Kaito electronic KA800 - Manual (Page 15)

12
RADIO OPERATION
2. Tuning Knob
(1) Turn on the radio.
(2) Select your desired band.
(3) Rotate the <Tuning Knob> with the frequency increasing
or decreasing on display. Stop tuning as soon as you
receive a clear signal.
If "H" is displayed in the bottom left of
the display, it means you can't tune in
the station by rotating the <Tuning Knob> as normal. In this
case press <AUTO-> or <AUTO+> button quickly to enter
the Frequency Tuning mode and then you can tune in your
desired station as normal.
The Sign of “H” & “E”:
“H” means the radio is in Preset Frequency Tuning Mode.
“E” means the radio is in Frequency Tuning Mode.
3. Auto Tuning Storage (ATS)
(1) Turn on the radio, select the
radio working mode.
(2) Select your desired band.
(3) Press & hold <M/ATS/TIME> button with the frequency
increasing or decreasing. You will notice the signal
strength indicator changing and the stored addresses
(memory preset locations) increasing in display. Once you
see this, release the button. The unit is auto tuning and
saving all strong signals into memory.
NOTE:
1. While in ATS (Auto Tuning Storage), the best reception
can be achieved when near a window or outdoors.
2. When you use ATS, the new frequencies will replace the
old ones when in the Auto Tuning Storage mode.
3. Do not use ATS while charging.