Kawasaki P9723 - Manual (Page 12)

12 P9723pr-0920
• Fit the brush guard onto the front clip.
• Insert two #8 x
3 /
4
" screws into the lower holes in the brush
guard and tighten.
Brush Guard
14
• Insert two #8 x 2" screws into the upper holes in the brush
guard and tighten.
15
• Fit both hand grips on the ends of the handlebar.
Hint: If it is difficult to slide a hand grip onto the handlebar,
moisten the inside of the grip with water.
16
• Locate the opening under the drive buttons.
• Reach into the opening and pull the high speed connector out
through the opening.
• See page 18 for information on high speed operation.
17
Connector
Drive Buttons
Hand Grip
Hand Grip
BACK VIEW