Kawasaki P9723 - Manual (Page 22)

22 P9723pr-0920
PROBLEM POSSIBLE CAUSE SOLUTION
Vehicle runs in low speed, but
does not run in high speed.
Please note: The vehicle is
designed to operate in low
speed only in reverse.
High speed hook-up not disconnected. The vehicle was pre-set to run only in low speed. To allow the
vehicle to run in low and high speed, you must connect the High
Speed connectors. Follow the instructions on page 18.
Note: The high speed connectors must be joined to use the
high speed grip.
When the foot pedal is pressed
one rear wheel spins Operation of vehicle in low speed It is possible that only one rear wheel may spin when both rear
wheels are raised off the ground and the vehicle is in low speed.
This does not necessarily indicate a problem. Check for proper
operation of the drive system by raising the rear wheels off the
ground and pressing the foot pedal. If only one rear wheel spins,
carefully press your hand on the spinning wheel to slow it down.
The other rear wheel should begin to spin. If the other rear wheel
does not begin to spin, there may be a problem with the vehicle.
Contact your local Power Wheels
® authorized service center for
diagnosis and repair.
Sometimes the vehicle doesn’t
run, but other times it does Loose wire or connector Check all wires and connectors. Make sure the motor harness
connector is plugged into the battery, and that there are no loose
wires around the motors.
Motor or electrical switch damage The electrical switches can become corroded due to exposure to
water or moisture, or can jam due to loose dirt, sand or gravel.
Contact your local Power Wheels® authorized service center for
diagnosis and repair.
When the foot pedal is
pressed, the vehicle won’t run
without a push Loose wire or connector Check all wires and connectors. Make sure the motor harness
connector is plugged into the battery, and that there are no loose
wires around the motors.
“Dead Spot” on motor Contact your local Power Wheels ® authorized service center for
diagnosis and repair.
Battery's thermal fuse
constantly "trips", but the
vehicle is not overloaded
nor the driving conditions
too severe Damaged battery Contact your local Power Wheels ® authorized service center for
diagnosis and repair.
Child is switching between FORWARD
and REVERSE without stopping Teach your child to stop the vehicle before switching direction.
Loud clacking or grinding noise
from a motor-gearbox Broken gears Contact your local Power Wheels ® authorized service center for
diagnosis and repair.
Charger gets warm during use It is normal for some chargers to get
warm during use and is not reason for
concern. No action required.
If your charger does not get warm during use, it does not mean
that it is not working properly.
Battery makes a sizzling or
gurgling noise when charging It is normal for some batteries to make
noise and swell slightly while charging
and is not reason for concern. No action required.
If your battery does not make noise or swell slightly during
charging, it does not mean that it is not accepting the charge.