Warning, Assembly – Kawasaki P9723 User Manual

Page 8

Advertising
background image

8

P9723pr-0920

Children can be harmed by small parts,
sharp edges and sharp points in the vehicle's
unassembled state, or by electrical items.
Care should be taken in unpacking and
assembly of the vehicle. Children should
not handle parts, including the battery,
or help in assembly of the vehicle.

• Fit a

3

/

8

" -16 hex nut onto one end of the rear axle. Hand tighten

the hex nut to hold in place.

• Plug the charger connector into the battery

A

.

• Plug the charger into a standard wall outlet

B

.

Notes:
- Use the charger only in a wall outlet. Do not plug the AC

adaptor into a ceiling outlet.

-

If power flow to the wall outlet is controlled by a switch,

make sure the switch is “ON”.

- The power indicator on the charger does not indicate the

charge status of your battery. The power indicator allows
you to see that there is power from the wall outlet.

• Before first-time use, charge the battery for

at least 18 hours.

Never charge the battery longer than 30 hours.

• Recharge the battery for at least 14 hours after each use of

your vehicle. Do not charge the battery longer than 30 hours.

• Once the battery is charged, disconnect the charger connector

from the battery. Unplug the charger from the wall outlet. The
battery is now ready to be installed in your vehicle. Please
see the Battery Installation section on page 15 for detailed
instructions on installing your battery. If your battery is already
installed in your vehicle, simply re-connect the motor harness
connector to the battery.

Battery

Charger

Connector

1

ASSEMBLY

A

B

Power

Indicator

Rear Axle

3

/

8

"

-16 Hex Nut

WARNING

Advertising