Kawai CN31 - Manual (Page 52)

Page
52
APPENDICES
6
6. Place the stand so that the backside of the stand assembly
rests against a wall, and then slowly and carefully insert
the piano. Ensure that more than two people work on the
assembly. If attempting to insert the piano without resting the
stand against a wall, support the back of the stand using your
foot or leg to prevent the stand from sliding backwards.
7. Press the end panel (C) of the stand to the piano (A), and
then fasten the piano (A) to the stand with four screws (I).
8. Fix the headphone hook and screws (K).
* If the headphone hook will not be required, it can be kept with
the instruction manual.
9. Raise the unit and tightly fasten the loosely fastened screws
(H) with the * symbol.
10. Insert the connector of the pedal cord into the receptacle,
and fi x the cord with the cord clamp (J) (make sure that the
protrusion of the connector is facing the correct direction, and
insert the connector straight).
11. Turn the adjustor bolt (E) at the bottom of the pedal stand until
the bolt fi rmly touches the fl oor and supports the pedal board.
12. Insert the power cord (L) into the piano.
13. Remove the protective fi lm from the display.
Assembly is now complete.
Caution
y Ensure that the piano is not dropped
on an individual's feet, and that fingers,
hands and feet are not caught in the
piano.
Caution y Ensure that the piano and the stand
are securely fastened together with the
screws, preventing the possibility of the
piano falling.
Caution y Ensure that the adjuster bolt (E) firmly
touches the floor, supporting the pedal
board and preventing damage.
When moving the piano, remove the ad-
justor bold (E) and readjust after moving
has been completed.
11
(E)
12
(L)
9 y 10
(J) (J)
(H)*
Protrusion
13
6 y 7 y 8
(A)
(K)
(I)
(I)