Kodak 777 User Manual
Page 20
20
4
Remove the lamp door by unscrewing the screw then sliding the door
off.
5
Remove the lamp module by unscrewing the 2 screws then pulling the
bail wire. Dispose of the lamp in an environmentally proper manner.
6
Install the new lamp module, making sure that it is properly seated. Be
careful not to touch the interior components of the projector.
7
Snap the bail wire back into its flat position against the lamp module.
8
Tighten the single screw.
9
Replace the lamp door by sliding the tabs into the tab bays and tighten-
ing the two screws.
10
Plug in the power cable, then press the Power button on the remote to
turn the projector back on.
11
Reset the lamp hour timer by navigating to the Service menu and select-
ing Lamp Reset. See page 18 for details.
loosen screw on lamp door
and slide door off
loosen 2 screws and remove
module using bail wire