Kawai CP67 - Manual (Page 14)

– 14 –
2. STYLE
(1) Select a style.
Press one of the STYLE buttons. The LED of the selected STYLE button
will light to indicate which style is currently in being used. Pressing the
active STYLE button again will switch to the alternative style of the STYLE
button.
(2) Start the style.
Pressing the START/STOP button will start the style. Pressing it again
will stop the style.
Pressing the INTRO/ENDING button will start the style with an intro
section. Pressing it again will stop the style with an ending section.
Pressing the FILL IN button while the style is running will play a short fill
in section which embellishes the style and leads to the next variation section.
When the SYNC button is pressed, the style will not start until you play a
note or chord on the keyboard.
(3) Adjust the Tempo.
You can adjust the tempo by using the VALUE buttons. The tempo is
shown in the LED display when the style is running . If the tempo is not
shown in the LED display, touching the VALUE buttons will activate the
LED display to show the tempo.
(4) Turn on the accompaniment.
When the ACC button is pressed, the CP piano will play a complete
accompaniment style. In addition, the keyboard will be split into two
sections-upper and lower keyboard. When the ACC button is turned OFF
only the rhythm accompaniment will be played. With the ACC button
ON, when you play a chord in the lower keyboard the accompaniment
style will automatically follow the chords you play. The accompaniment
system is capable of following single finger as well as more complex chord
voicings. If you want to change the volume for the style, use the Balance
slider while holding down the ACC button. The LED display shows
you the volume level for the style from 0 (soft) to 127 (loud). If you want
to change the split point for the lower keyboard, press a key on the
keyboard while holding down the ACC button. The pressed key will be
the lowest note for the upper keyboard.